Trumpf BendMaster 150, Руководство оператора

Страница: 216 / 258

Name Description
"Run mode" Various parameters, which can influence the position recognition results, are saved
for each position recognition model (e.g. "Contrast" or "Acceptance").
■ These parameters cannot be changed if "Run mode" is active.
■ If "Run mode" is deactivated, position recognition is not possible. However, the
parameters can be modified (e.g. "Acceptance" or "Contrast").
Search Starts a manual search with the set parameters on the current image recording.
The results are graphically displayed and the quality and contrast are shown in the
"Position recognition results" field.
Image recording Starts manual image recording with the parameters entered in "Image recording set-
tings".
Create model The search contour programmed in TruTops Bend is displayed in the original state
and in yellow. It can be modified if required:
■ Press Yes to use the contour (is then displayed in green).
■ Press No if you do not want to use the contour (is then displayed in red).
■ Press Cancel to cancel contour processing.
Tip
The omission of CAD data may be a practical option if, for example, bore holes
in the model are of a different size than in the actual part.
Note
No closed contour may be interrupted by omitting elements.
Save settings Saves the user-defined settings for the currently loaded position recognition model.
The saved settings are available again if this model is reloaded for the next position
recognition process.
If the "Use Pattern Settings" is selected, the saved settings are used.
"Position recognition
results" The search results are displayed.
"Quality" Displays the quality of the results of the last position recognition process.
Note
To ensure sufficient process reliability, this result should be on average approx. 10%
above the nominal value set in
Acceptance .
"Contrast" Specifies the contrast in percent at which the position recognition process is only
just accepted in order to obtain valid results. 100% contrast: maximum contrast.
Black pixels on white pixels.
■ Typical fine position values: 20 - 50.
■ Typical approximate position values: 10 - 30.
"Results" ■ Shows the number of results found
"Index" If a position recognition process provides several results, all results can be
displayed one after another with "Index". The result with index 0 is used.
+ shows the next result.
- shows the previous result.
Note
The fine recognition results are already sorted by the method set (quality or posi-
tion).
'c:\control\application\
TeachTalk\...' Currently loaded search contour.
"Position recognition set-
tings" Parameters for position recognition can be set.
4
‐
122
Error handling 2015-06-01
B579EN