Trumpf BendMaster 150, Руководство оператора

Страница: 186 / 258

Setting the backstop resistor for single
bending operations
Condition
■ Backstop resistors have been activated by the TRUMPF
Service Department.
1. Press > Set up > Bending parameters .
2. Select "Bending number" if the backstop resistor is to be
adjusted for a single bending operation.
3. Select "When stopping" with a checkmark. The backstop
resistor is active while the backgauge approaches its posi-
tion.
or
Ø Select "When moving" with a checkmark. The backstop
resistor is active while the backgauge withdraws from the
workpiece.
4. Enter the strength of the backstop resistor between 0 and
100 %:
−
"Left": actuation of the left backstop resistor.
− "Right": actuation of the right backstop resistor.
5. Press For all bendings if the backstop resistor setting is to
be applied for all bending operations in the program.
6.13 Program, loading
Opening the running in program
Conditions
■ All axes have been referenced. (see "Referencing the Bend-
Master", pg. 4
‐
39) .
■ The system is ready for operation in automatic mode.
■ No error messages, i.e. green LED on the portable manual
control unit lights up (acknowledge error if red LED is on).
■ BendMaster is ready for operation (the GREEN button was
pressed, and the "BendMaster“ icon is green).
■
No gripper set up.
4
‐
92
Running in a TruTops program 2015-06-01
B579EN