Trumpf BendMaster 150, Руководство оператора

Страница: 21 / 258

2. Operational safety
The machine can become a source of danger if it is used inap-
propriately or for purposes other than those intended:
■ Dangers to the safety of the operator.
■ Damage to the machine and other material assets of the
operator.
■ Negative effect on the effective functioning of the machine.
2.1 Intended use
The user may use the machine only in the industrial sector.
The installation, operating and transport conditions prescribed by
TRUMPF must be adhered to and the maintenance work must
be performed. The installation and operation must comply with
the relevant national regulations that are valid in the country of
operation. The user must adhere to the national regulations.
The user may only manipulate cold sheets using the machine.
The sheets are taken from the loading or unloading position,
bent on the press brake according to the machining cycle and
then, depending on the design version, either set down at the
loading or unloading position or transported onwards from the
unloading position.
The following is not allowed:
■ Unauthorized alteration or conversion of the machine by the
user or personnel.
■ Any working procedure that impairs the safety.
■ The machining of hot, splintering or brittle materials.
■ Use of tools from other manufacturers without consultation
with and release by TRUMPF.
■ Misuse of press beams for storing unused tools.
■ The machining of scarred or sandblasted sheets (does not
apply to machining with the pivoted-jaw gripper).
■ The machining of sheets with unsuitable gripper technology
(e.g. perforated sheets with suction cups).
■ Exceeding the maximum workpiece dimensions of:
−
2000 x 1000 mm with BendMaster (60).
− 3000 x 1500 mm with BendMaster (150).
− Profiles: 2500 x 1000 mm with BendMaster (60).
− Profiles: 4000 x 500 mm with BendMaster (150).
■ Exceeding the maximum workpiece weight of:
−
40 kg with BendMaster (60).
− 110 kg with BendMaster (150).
B579EN
2015-06-01 Operational safety
1
‐
5