Trumpf BendMaster 150, Руководство оператора

Страница: 140 / 258

4. Switching off the BendMaster
4.1 Stopping BendMaster and TruBend in
any emergency or after a malfunction
Ø Press EMERGENCY STOP on the control panel.
or
Ø Press EMERGENCY STOP on the portable manual con-
trol unit.
or
Ø Press EMERGENCY STOP on the outside of one of the
posts of the safety fencing.
or
Ø Press EMERGENCY STOP on the inside of post 4.
or
Ø In manual mode only:
− Release the ENABLE KEY on the portable manual con-
trol unit.
or
Ø In manual mode only:
− Fully press the ENABLE KEY on the portable manual
control unit.
4.2 BendMaster, switching off
Condition
■ The control is in the > Position > Automatic menu.
1. Press Stop to stop the program.
2. If there is a blank on the BendMaster, move into unloading
position and set down the blank.
3. Release and deposit the gripper.
4. Select
Move , Robot in home position .
The safe home position must be approached so that the
BendMaster does not have to be referenced again after
switching on.
5. Change to the TOS user interface with <Alt>+<Tab>.
6. Press
Exit , Exit control system .
7. Press Exit Windows XPe once the control has been shut
down.
8. Enter
Yes
. The visualization PC is shut down.
4
‐
46
Switching off the BendMaster 2015-06-01
B579EN