Trumpf BendMaster 150, Руководство оператора

Страница: 137 / 258

Conditions
■ Manual or automatic operating mode is active.
■ No error messages, i.e. green LED on the portable manual
control unit lights up (acknowledge error if red LED is on).
(see "Enabling conditions for operation modes", pg. 4
‐
17) .
■ No error messages, i.e. green LED on the portable manual
control unit lights up (acknowledge error if red LED is on).
■ In manual mode: The BendMaster is ready for operation
(pulse trigger switch on the portable manual control unit has
been pressed, "BendMaster" icon is green).
or
■ In automatic mode: BendMaster is ready for operation (the
GREEN button was pressed, and the "BendMaster“ icon is
green).
1. Press the > Press > Press servicing menu on the portable
manual control unit.
Fig. 46147
2. Starting referencing
Ø Manual mode: Press and hold the ENABLE KEY on the
manual control unit.
Ø Press Start press .
or
Ø Automatic mode: Press the GREEN button.
Ø Press Start press .
The hydraulic unit is started. The upper and lower tools are
clamped. The press beam is referenced. The backgauge
moves into position.
B579EN
2015-06-01 Switching on and referencing the BendMaster
4
‐
43
Referencing TruBend