Trumpf BendMaster 150, Руководство оператора

Страница: 190 / 258

The overlay can start at the earliest halfway up the shorter path.
Teaching a point
If the position of a point has to be corrected manually when run-
ning in a part, the point can be taught.
Notes
■ Taught points can not be reversed .
■ The current position of the regripping station is also taught.
1. Interrupt the program at the portable manual control unit
using the red STOP key.
2. Approach the point to be taught step-by-step.
3. Approach the new position manually (make sure the correct
coordinate system is used).
4. Mark the program point to be taught. This program point is
displayed on a yellow background.
5. In the "Run in" mask, press Teach position .
6. Confirm the query with OK .
Points, editing
1. Interrupt the program at the portable manual control unit
using the red STOP key.
2. Mark the program point to be edited. It is displayed on a yel-
low background.
3. No .
4
‐
96
Running in a TruTops program 2015-06-01
B579EN