All stacks can be disabled apart from the stack modes
L stack
empty
,
U stack (A stack) full
and
L no coordinate
. The disabled
stacks are no longer used by the control system.
3. Press
Process
,
Lock/unlock stack
. The stack mode is
changed:
The height of a loading stack can be changed manually. Since
the height measurement is a relative measurement between the
BendMaster and the highest blank, there may be minimum devi-
ations to the measured height.
4. Press
Process
,
Change Height
.
5. Enter the stack height.
6. Press
OK
. The height is changed.
If the stack does not have the
L height OK
status, the stack
mode is accordingly changed:
−
From
L no coordinate
to
L height OK
.
Note
When the first blank is picked up from a stack in
L height
OK
stack mode, the BendMaster automatically measures the
height.
Blanks can only be picked up from an active loading stack. Fin-
ished parts can only be deposited on an active unloading stack.
Only one loading and unloading stack can be active at a time.
If a loading stack is in
L coordinate OK
stack mode, sheets can
be picked up, since the BendMaster automatically measures the
height.
7. Press
Process
,
Activate/deactivate
. The stack mode changes:
−
From
L height OK
to
L stack active
.
−
From
A stack ready
to
A stack active
.
−
Or vice versa.
In the standard sequence, the stacks are automatically acti-
vated according to their processing sequence. Manually acti-
vated stacks are processed first completely.
This is practical for fine recognition to be able to rotate a sym-
metrical loading stack through 90° (e.g. if the first fine
recognition area of the BendMaster cannot be reached).
8. Press
Process
,
Rotate stack 90°
.
This is practical in order to be able to carry out fine recognition
rotated at any angle between 0° and 180°.
9. Press
Process
,
Rotate stack by x
.
10. In "Parameters," enter the angle by which the loading stack
is to be rotated.
B579EN
2015-06-01
Running in a TruTops program
4
‐
81
Disabling a stack
Changing the stack height
Activating/deactivating a
stack
Turning a loading stack 90°
Turning a loading stack by x
°
Содержание BendMaster 150
