Trumpf BendMaster 150, Руководство оператора

Страница: 159 / 258

or
Ø Press the desired area in the graphic (see "Loading and
unloading areas", pg. 4
‐
62) .
Do not confuse the loading and unloading areas!
2. Moving an area
Ø Press the value to be changed. The numeric keyboard
appears.
Ø Enter the value.
Ø Press OK .
or
Ø Move the area into the graphic using the drag & drop
method
(see "Fig. 46232", pg. 4
‐
64) .
Notes
− Moving unloading areas by means of drag & drop is only
possible in Z direction.
− The coordinate system in Z direction is stuck onto the
floor lane cover.
− The origin of the coordinate system in the X direction is
at the center of the shaft of the A axis. The coordinates
become positive in the direction of the TruBend and neg-
ative in the direction of the loading area.
− Moving unloading areas in X direction is only possible by
changing the starting point. However, it may be the case
that the BendMaster can no longer approach the unload-
ing positions.
− If the sheets of the loading stack are larger than the pal-
let, a larger loading area must be defined accordingly.
Name Description
Starting point X and Z coordinates of the bottom, left corner of
the area selected under active areas. This point is
displayed in red in the diagram
(see "Fig. 46232",
pg. 4
‐
64) .
"Length" Length of the area selected under "Active Areas" in
the Z direction in [mm].
"Width" Width of the area selected under "Active Areas" in
the X direction in [mm].
The length and width range can also be moved
using the drag & drop method:
■
Select an area.
■ Position the cursor at the corner diagonally
opposite the starting point.
■ Adapt the area.
"Pallet height" Height of the transport medium holding the work-
piece stack.
B579EN
2015-06-01 Running in a TruTops program
4
‐
65