Trumpf BendMaster 150, Руководство оператора

Страница: 204 / 258

7. Working at the press brake without
BendMaster
7.1 Working at the press brake without
BendMaster
Conditions
■ BendMaster and TruBend have been switched on.
■ Working at the press brake without BendMaster
■ All EMERGENCY STOPs are released.
■ 6-axis-sensor fingers fixated.
1. Use the "Robot in parking position" travel function to move
the BendMaster into the parking position in manual or auto-
matic mode
(see "Executing travel functions", pg. 4
‐
48) .
2. Switch from BendMaster operating mode to TruBend operat-
ing mode manually.
The covering of the floor lane is not designed for standing
on or storing parts on it!
Damage to the floor lane.
Ø Do not step on the covering.
Ø Do not deposit any workpieces on the covering.
3. Close all safety doors if the operator is inside the bending
cell.
4. Activate the catch with the green button on post 1.
5. Operate the TruBend manually (refer to the "TruBend opera-
tor's manual").
6. Deactivate the catch with the red button on post 1 if neces-
sary:
Ø Press the red button on the control panel.
or
Ø Press the EMERGENCY STOP impact button.
Exceptions: The two EMERGENCY STOP impact buttons
on the TruBend control and control panel and the fully
pressed foot switch at the control panel. (In this case the
system stops, but the catch remains active.
4
‐
110
Working at the press brake without BendMaster 2015-06-01
B579EN
NOTICE