Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 95 / 1071

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
95 User Manual 1178.3370.02 ─ 11
Using this overview, you can easily configure an entire channel setup from input over
processing to output and analysis by stepping through the dialog boxes as indicated.
In particular, the "Overview" provides quick access to the following configuration dialog
boxes (listed in the recommended order of processing):
1. "Select Measurement"
See Chapter 6.2, "Measurements and Results" , on page 96
2. Input
See Chapter 6.3.1, "Radio Frequency Input" , on page 276
3. Amplitude
See Chapter 6.5, "Amplitude and Vertical Axis Configuration" , on page 310
4. Frequency
See Chapter 6.4, "Frequency and Span Configuration" , on page 303
5. (Optionally:) Trigger/Gate
See Chapter 6.7, "Trigger and Gate Configuration" , on page 334
6. Bandwidth
See Chapter 6.6.2, "Bandwidth, Filter and Sweep Settings" , on page 324
(For SEM measurements: SEM Setup, see Chapter 6.2.7.5, "SEM Configuration" ,
on page 173)
(For Spurious measurements: Spurious Setup, see
Chapter 6.2.8.4, "Spurious
Emissions Measurement Configuration" , on page 203)
7. (Optionally:) Outputs
Requires option R&S FPL1-B5, see Chapter 6.3.4, "Output Settings" , on page 301
8. Analysis
See Chapter 6.10, "Trace Configuration" , on page 390 and Chapter 6.9, "Marker
Usage" , on page 348
9. Display
See Chapter 5.6, "Configuring Result Displays" , on page 88
To configure settings
► Select any button to open the corresponding dialog box.
Select a setting in the channel setup bar (at the top of the channel setup tab) to
change a specific setting.
Preset Channel Setup
Select the "Preset Channel" button in the lower left-hand corner of the "Overview" to
restore all measurement settings
in the current channel setup to their default values.
Note: Do not confuse the "Preset Channel" button with the [Preset] key , which restores
the entire instrument to its default values and thus closes all channel setups on the
R&S FPL1000 (except for the default channel setup)!
Remote command:
SYSTem:PRESet:CHANnel[:EXEC]
on page 924
Configuration Overview