Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 220 / 1071

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
220 User Manual 1178.3370.02 ─ 11
Range <x> Start/Stop
Defines the start and stop points of the range within the tracing period. Make sure the
value for the stopping time is smaller than the length of the period.
Note: You can define the time values with a greater numerical resolution than is dis-
played; the values are only rounded for display.
Remote command:
[SENSe:]SWEep:EGATe:TRACe<t>:STARt<gr>
on page 693
[SENSe:]SWEep:EGATe:TRACe<t>:STOP<gr>
on page 694
Scaling for Statistics Diagrams
Access : "Overview" > "Amplitude" > "Scale" tab
Or : [AMPT] > "Scale Config"
For statistics displays, scale settings are available for both the y-axis and the x-axis.
The remote commands required to perform these tasks are described in Chap-
ter 10.6.9.4, "Scaling the Diagram" , on page 694.
Figure 6-32: Scale settings for CCDF diagram
In statistical diagrams, the x-axis displays the signal level values (= y-axis in standard
display), while the y-axis displays the probability of the values.
X-Axis ..........................................................................................................................221
└ Ref Level .......................................................................................................221
└ Range ........................................................................................................... 221
└ Shifting the Display (Offset) .......................................................................... 221
Y-Axis .......................................................................................................................... 221
└ Y-Unit ............................................................................................................ 221
Measurements and Results