Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 577 / 1071

Network Operation and Remote Control
R&S
®
FPL1000
577 User Manual 1178.3370.02 ─ 11
aborted and synchronization is achieved by setting the corresponding bits in the
registers of the status reporting system.
●
Bit 6 (User Request) of the Event Status Register is set.
If the status reporting system is configured accordingly, this bit immediately causes
the generation of a service request (SRQ) to inform the control software that the
user wishes to return to front panel control. For example, this can be used to inter-
rupt the control program and to correct instrument settings manually. This bit is set
each time the "LOCAL" softkey is pressed.
Remote command:
SYSTem:KLOCk
on page 967
9.5 How to Set Up a Network and Remote Control
Risk of network failure
Consult your network administrator before performing the following tasks:
●
Connecting the instrument to the network
●
Configuring the network
●
Changing IP addresses
●
Exchanging hardware
Errors can affect the entire network.
Remote operation
You can operate the instrument remotely from a connected computer using SCPI com-
mands. Before you send remote commands you must configure the instrument in a
LAN network or connect it to a PC via the GPIB interface as described in
Chap-
ter 9.5.1, "How to Configure a Network" , on page 578.
Remote Desktop
In production test and measurement, a common requirement is central monitoring of
the T&M instruments for remote maintenance and remote diagnostics. Equipped with
the Remote Desktop software of Windows, the R&S
FPL1000 ideally meets require-
ments for use in production. The computer that is used for remote operation is called
"controller" here.
The following tasks can be performed using Remote Desktop:
●
Access to the control functions via a virtual front panel (soft front panel)
●
Printout of measurement results directly from the controller
●
Storage of measured data on the controller's hard disk
This documentation provides basic instructions on setting up the Remote Desktop for
the R&S
FPL1000. For details refer to the Windows operating system documentation.
How to Set Up a Network and Remote Control