Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 794 / 1071

Remote Commands
R&S
®
FPL1000
794 User Manual 1178.3370.02 ─ 11
Example: INIT:CONT OFF
Selects single sweep operation
CORR:METH TRAN
Selects a transmission measurement.
CORR:COLL THR;*WAI
Starts the measurement of reference data using direct connec-
tion between generator and device input and waits for the sweep
end.
Usage: Setting only
Manual operation: See "Calibrate Reflection Short" on page 296
See "Calibrate Reflection Open" on page 296
[SENSe:]CORRection:METHod <Type>
This command selects the type of measurement to be performed with the generator.
This command is only available if the Tracking Generator is active (see
OUTPut<up>[:STATe]
on page 790).
Parameters:
<Type> REFLection
Selects reflection measurements.
TRANsmission
Selects transmission measurements.
*RST:
TRANsmission
Example: CORR:METH TRAN
Sets the type of measurement to "transmission".
Manual operation: See "Calibrate Transmission" on page 296
See "Calibrate Reflection Short" on page 296
See "Calibrate Reflection Open" on page 296
[SENSe:]CORRection:RECall
This command restores the measurement configuration used for calibration.
This command is only available if the Tracking Generator is active (see
OUTPut<up>[:STATe]
on page 790).
Example: CORR:REC
Manual operation: See "Recall Cal. Settings" on page 297
Setting Basic Spectrum RF Measurement Parameters