Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 901 / 1071

Remote Commands
R&S
®
FPL1000
901 User Manual 1178.3370.02 ─ 11
Parameters:
<Name> String containing the limit line name.
*RST:
REM1 to REM8 for lines 1 to 8
Manual operation: See "Name" on page 435
CALCulate<n>:LIMit<li>:UNIT <Unit>
This command defines the unit of a limit line.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<Unit> DBM | DBPW | WATT | DBUV | DBMV | VOLT | DBUA |
AMPere | DB | DBUV_M | DBUA_M | DBM_mhz | DBUV_mhz |
DBMV_mhz | DBUa_mhz | DBUV_m | DBUa_m | DBUV_mmhz |
DBUa_mmhz | DBPW_mhz | DBPT_mhz | DBPT | (unitless)
If you select a dB-based unit for the limit line, the command
automatically turns the limit line into a relative limit line.
*RST:
DBM
Manual operation: See "Y-Axis" on page 436
CALCulate<n>:LIMit<li>:UPPer[:DATA] <LimitLinePoints>
This command defines the vertical definition points of an upper limit line.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<LimitLinePoints> Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with
CALCulate<n>:
LIMit<li>:CONTrol[:DATA]
. If not, the R&S FPL1000 either
adds missing values or ignores surplus values.
The unit depends on
CALCulate<n>:LIMit<li>:UNIT
on page 901.
*RST:
Limit line state is OFF
Default unit: DBM
Manual operation: See "Data Points" on page 436
CALCulate<n>:LIMit<li>:UPPer:MARGin <Margin>
This command defines an area around an upper limit line where limit check violations
are still tolerated.
Setting Basic Spectrum RF Measurement Parameters