![background image](http://html1.mh-extra.com/html/rands/znb/znb_user-manual_3286757412.webp)
GUI Reference
R&S
®
ZNB/ZNBT
412
User Manual 1173.9163.02 ─ 55
Sweep Stage
Sweep Controller Display
in "Continuous" Sweep
Mode
in "Single" Sweep Mode
Sweeping m/n
if n = #Sweeps > 1
Measurement results are being calculated
Continuous Calculation
Calculation
1)
The VNA is sweeping or waits for a trigger signal.
6.10.4.2
Restart Manager Dialog
The "Restart Manager" dialog defines whether the active sweep mode ("Continuous" or
"Single") and the "Sweeps" value are valid for all channels in the active recall set or for
the active channel only.
Access:
CHANNEL – [SWEEP] > "Sweep Control" > "Restart Manager..."
This dialog is relevant / accessible in compatibility modes only (see
Related information
Refer to
Chapter 5.1.4, "Sweep Control"
Sweep All Channels
Apply the sweep control settings to all channels in the active recall set. The number of
sweeps in a "Single" sweep sequence is equal to the selected number of "Sweeps"
times the number of channels. The sequence starts with the first sweep in channel no.
1.
Tip:
In remote control, it is possible to retrieve the results acquired in any of the
sweeps within a single sweep group.
Remote command:
INITiate<Ch>[:IMMediate]:SCOPe ALL
[SENSe<Ch>:]SWEep:COUNt
Sweep Softtool