Command Reference
R&S
®
ZNB/ZNBT
1297
User Manual 1173.9163.02 ─ 55
Parameters:
<StopPower>
Start or stop power of the sweep.
Range:
-150 dBm to +100 dBm. The usable power range is
frequency-dependent; refer to the data sheet.
Increment: 0.01 dB
*RST:
-25 dBm start power, 0 dBm stop power
Default unit: dBm
Example:
SWE:TYPE POW
Activate a power sweep.
SOUR:POW:STAR -6; STOP 10
Select a power sweep range between -6 dBm and +10 dBm.
Manual operation:
See
Note:
If the start power entered is greater than the current stop power
(
SOURce<Ch>:POWer<PhyPt>:STOP
), the stop power is set to the start power plus
the minimum power span (increment) of 0.01 dB.
If the stop power entered is smaller than the current start power
(
SOURce<Ch>:POWer<PhyPt>:STARt
), the start power is set to the stop power
minus the minimum power span of 0.01 dB.
8.3.16
STATus Commands
The
STATus:...
commands control the status reporting system. Status registers are
not reset by *RST; use *CLS for this purpose.
....................................................................................1298
STATus:QUEStionable:INTegrity[:EVENt]?
......................................................................1298
STATus:QUEStionable:INTegrity:HARDware[:EVENt]?
.....................................................1298
STATus:QUEStionable:LIMit<Lev>[:EVENt]?
...................................................................1298
STATus:QUEStionable:CONDition?
................................................................................1298
STATus:QUEStionable:INTegrity:CONDition?
..................................................................1298
STATus:QUEStionable:INTegrity:HARDware:CONDition?
.................................................1298
STATus:QUEStionable:LIMit<Lev>:CONDition?
...............................................................1298
..................................................................................... 1299
STATus:QUEStionable:INTegrity:ENABle
........................................................................1299
STATus:QUEStionable:INTegrity:HARDware:ENABle
.......................................................1299
STATus:QUEStionable:LIMit<Lev>:ENABle
.....................................................................1299
STATus:QUEStionable:NTRansition
............................................................................... 1299
STATus:QUEStionable:INTegrity:NTRansition
................................................................. 1299
STATus:QUEStionable:INTegrity:HARDware:NTRansition
................................................ 1299
STATus:QUEStionable:LIMit<Lev>:NTRansition
.............................................................. 1299
STATus:QUEStionable:PTRansition
............................................................................... 1300
STATus:QUEStionable:INTegrity:PTRansition
................................................................. 1300
STATus:QUEStionable:INTegrity:HARDware:PTRansition
................................................ 1300
STATus:QUEStionable:LIMit<Lev>:PTRansition
.............................................................. 1300
.............................................................................................. 1300
SCPI Command Reference