![background image](http://html1.mh-extra.com/html/rands/znb/znb_user-manual_32867571249.webp)
Command Reference
R&S
®
ZNB/ZNBT
1249
User Manual 1173.9163.02 ─ 55
[SENSe:]UDSParams<Pt>:PARam
<PortString>
Creates or redefines a user-defined physical port (see
Chapter 5.3.1.2, "Redefined S-
on page 116). This causes a factory reset.
Note
that the factory reset deletes all switch matrix RF connections, so the RF configu-
ration for switch matrices (see
SYSTem:COMMunicate:RDEVice:SMATrix:
) has to be done
after
the port redefinition.
Suffix:
<Pt>
.
Number of the redefined physical port.
Parameters:
<PortString>
String representation '<Source>:<a wave>:<b wave>' where
<Source> =
i
refers to (original) VNA ports
<Source> = G
i
refers to external generator ports
<a wave>, <b wave> is one of the original a
i
or b
i
,
without reusing the same port in different (redefined) ports
Example:
SENSe:UDSParams:ACTive OFF
resolves all redefined ports
SENSe:UDSParams1:PARam '1:b2:b3'
redefines physical port 1 as source = (original) physical port 1,
reference receiver = physical port 2, measurement receiver =
physical port 3
SENSe:UDSParams:ACTive?
)
Manual operation:
See
8.3.15
SOURce Commands
The
SOURce...
commands affect the source settings of the R&S
ZNB/ZNBT.
8.3.15.1
SOURce:FREQuency...
The
SOURce:FREQuency...
commands configure the sources for frequency conver-
sion measurements and control the frequency and power of the internal signal source.
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMFixed
.................................................1249
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMODe
.................................................. 1250
SOURce<Ch>:FREQuency<PhyPt>[:CW]
...................................................................... 1251
SOURce<Ch>:FREQuency<PhyPt>:FIXed
..................................................................... 1251
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:EFRequency<Gen>
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:IFRequency
...........................1253
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMFixed
<arg0>[, <arg1>]
Assigns a fixed power to the RF, LO 1, LO 2, or to the IF signal.
SCPI Command Reference