![background image](http://html1.mh-extra.com/html/rands/znb/znb_user-manual_3286757558.webp)
GUI Reference
R&S
®
ZNB/ZNBT
558
User Manual 1173.9163.02 ─ 55
Background information
Refer to the following sections:
●
Chapter 5.7.4.2, "Scalar Mixer Measurements"
●
"Two-Stage Mixer Measurements"
6.12.6.1
Controls on the Mixer Mode Tab
Most of the "Mixer Mode" buttons are only enabled if the mixer measurement is set up
properly. They open wizards or dialogs:
●
"Mixer Meas Wizard...":
Chapter 6.12.6.2, "Mixer Presetting Wizard"
●
"Mixer Setup...":
Chapter 6.12.6.3, "(Mixer) Setup Dialog"
●
"SMARTerCal" – "Start... (Cal Unit)":
Chapter 6.12.6.4, "SMARTerCal (Cal
●
"SMARTerCal" – "Start... (Manual)":
Chapter 6.12.6.5, "SMARTerCal (Man-
●
"SMARTerCal" – "Repeat...":
launches the adequate "Mixer Meas"-specific wiz-
ard to repeat the currently active "SMARTerCal" (if available)
Reset Freq Conv
"Reset Freq Conv" disables all frequency conversion measurements in the active
channel, including intermodulation measurements.
A "Mix" label in the channel list indicates that a mixer measurement is active.
Remote command:
[SENSe<Ch>:]FREQuency:CONVersion
6.12.6.2
Mixer Presetting Wizard
The "Mixer Presetting" wizard guides you through the setup of a mixer measurement.
Channel Config Softtool