![background image](http://html1.mh-extra.com/html/rands/znb/znb_user-manual_32867571013.webp)
Command Reference
R&S
®
ZNB/ZNBT
1013
User Manual 1173.9163.02 ─ 55
<Bus>
RFFE bus interface
Query parameters:
<BytesToRead>
The number of bytes to be read back from the RFFE interface.
*RST:
0 to 16
Manual operation:
See
CONTrol<Ch>:RFFE<Bus>:SETTings[:STATe]
<EnableInSequence>
Enables/disables RFFE bus interface <Bus> in the Sweep Sequencer for channel
<Ch> (see
CONTrol<Ch>:SEQuence<Nr>:RFFE<Bus>:COMMand:DATA
and
CONTrol<Ch>:SEGMent<Nr>:SEQuence<Nr>:RFFE<Bus>:COMMand:DATA
).
Suffix:
<Ch>
.
Channel number
<Bus>
RFFE bus interface number
Parameters:
<EnableInSequence> Enabled state
Manual operation:
See
CONTrol<Ch>:RFFE<Bus>:SETTings:FREQuency
<ClockFrequency>
Sets/gets the clock frequency for channel <Ch> and RFFE bus <Bus>.
Suffix:
<Ch>
.
Channel number
<Bus>
1 or 2
RFFE bus number
Parameters:
<ClockFrequency>
Clock rate.
Possible values are 52/1664 MHz, 52/1663 MHz, ..., 52/2 MHz.
Range:
31.25 kHz to 26 MHz
Default unit: Hz
Manual operation:
See
CONTrol<Ch>:RFFE<Bus>:SETTings:VOLTage:IO
<IOVoltage>
CONTrol<Ch>:RFFE<Bus>:SETTings:VOLTage:LOW
<VoltageLow>
CONTrol<Ch>:RFFE<Bus>:SETTings:VOLTage:HIGH
<Voltage>
Sets/gets the IO, Low and High voltages for channel <Ch> and RFFE bus interface
<Bus>, respectively.
Note that these voltages are only applied while an RFFE command is executed using
CONTrol<Ch>:RFFE<Bus>:COMMand:SEND
or
.
SCPI Command Reference