Command Reference
R&S
®
ZNB/ZNBT
1336
User Manual 1173.9163.02 ─ 55
SYSTem:PRESet[:DUMMy]
Performs a preset, whose scope is defined using the
mand. The
command determines whether a factory
preset or a user-defined preset is performed.
Example:
SYST:PRES:SCOP SING
Define the scope of a preset: the active recall set is reset only.
SYST:PRES
Reset the parameters of the current recall set to their factory
defaults.
Manual operation:
See
SYSTem:PRESet:REMote[:STATe]
<Boolean>
Defines the behavior of the preset commands
*RST
Parameters:
<Boolean>
OFF (0)
*RST
and
SYSTem:PRESet
perform a factory preset.
ON (1)
*RST
and
SYSTem:PRESet
restore the user preset file selected
using
, if this file is available and
valid. Otherwise, they perform a factory preset.
Manual operation:
See
SYSTem:PRESet:SCOPe
<Scope>
Specifies whether the preset actions affect all open recall sets, or only the active recall
set.
command. The
*RST
com-
mand always resets all open recall sets.
Parameters:
<Scope>
ALL | SINGle
ALL
All open recall sets are deleted and a new recall set"Set1" is cre-
ated according to the current preset mode.
See
SINGle
The active setup is reset according to the current preset mode;
the name of the active setup and the parameters of all other set-
ups remain unchanged.
Example:
See
Manual operation:
See
SCPI Command Reference