Omron SYSDRIVE 3G3RV, Руководство пользователя

Страница: 354 / 446

6
-138
n
Storing Inverter set values in the Digital Operator (READ)
To
store Inverter set values in the Digital Operator, make the settings using the following method. Set o3-02
(Read
permitted selection) to 1 (read permitted).
An
error may occur while saving to memory. If an error is displayed, press any key to cancel the error display
and
return to the o3-01 display. Error displays and their meanings are shown below. (Refer to Chapter 7
Errors
when Using Digital Operator Copy Function.)
Select READ Permitted
Prevent
overwriting the data stored in EEPROM in the Digital Operator by mistake. With o3-02 set to 0, if you
set
o3-01 to 1, and perform the write operation, PrE will be displayed on the Digital Operator, and the write
operation
will be stopped.
Table 6.6 READ Function Procedure
Step
No.
Digital Operator Display Explanation
1
Press
the Menu Key, and select advanced pro-
gramming
mode.
2
Press
the ENTER Key, and select the parame-
ters
monitor display.
3
Display
o3-01 (Copy Function Selection) using
the
Increment Key and Decrement Key.
4
Press
the ENTER Key, and select the parame-
ters
setting display.
5
Change
the set value to 1 using the Increment
Key.
6
Set
the changed data using the ENTER Key.
The
READ function will start.
7
If
the READ function ends normally, End is
displayed
on the Digital Operator. Parameter
o3-01
is automatically reset to 0, and then the
display
returns to o3-01.
Error Display Meaning
You
are attempting to set o3-01 to 1 while o3-02 is set to 0.
Read
data length mismatch or read data error.
Tried
to write parameters to EEPROM on the Digital Operator, but unable to perform write opera-
tion.
DRIVE QUICK
VERIFY
AUTO
TUNING
ADV
DRIVE QUICK VERIFY ADV
AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK
VERIFY
ADV
AUTO
TUNING