Omron RX - 2, Руководство пользователя

Страница: 149 / 920

3 - 13
3 Operation
High-function General-purpose Inverter RX2 Series User’s Manual
3-1
Ove
rvi
ew o
f L
CD Operat
or
3
3-1-5 H
ow to Set Battery
and the
T
ime Setting
8
Make sure that the battery is inserted properly.
Turn OFF the inverter and turn it ON again.
When the battery is properly inserted, the inverter starts without errors.
If the same screen (procedure.7) comes up again, the battery is not set properly. Please try the
setting procedure from the beginning.
You can set the time by “09: Date and time” of the system setting screen. However, remember that you
should insert battery and set the time/date to activate the clock function. Also do not forget to switch the
battery level warning to “valid” for the battery charge detection.
Precautions for Safe Use
• When disposing of LCD operators and wasted batteries, follow the applicable ordinances of
your local government. When disposing of the battery, insulate it using tape.
• Do not short + and –, charge, disassemble, heat, put into the fire, or apply strong impact on
the battery. The battery may leak, explode, produce heat or fire. Never use the battery which
was applied strong impact due to such as fall on the floor, it may leak.
• UL standards establish that the battery shall be replaced by an expert engineer. The expert
engineer must be in charge of the replacement and also replace the battery according to the
method described in this manual.
Additional Information
• Even without battery, parameters saved in LCD operator and programs for DriveProgram-
ming are retained
• If you cannot see what is displayed on the LCD operator because the service life is near its
end, replace the LCD operator.
The following display must be indicated when products using lithium primary batteries
(with more than 6 ppb of perchlorate) are transport to or through the State of California,
USA.
Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
Label or mark the above display on the exterior of all outer shipping packages of your
products when exporting your products which the lithium primary batteries (with more than
6 ppb of perchlorate) are installed to the State of California, USA.