NEC NEAX 2000, Руководство по программированию

Страница: 812 / 1200

ND-91285-001(E)
DECEMBER, 1999
Page 30
Revision 1.0
(1/2)
ATTENDANT SPEED CALLING- SYSTEM SET UP
GENERAL DESCRIPTION
This service feature allowed the Attendant and is used to SPEED CALLING-SYSTEM SET UP oper-
ation.
STATION APPLICATION
All stations
OPERATING PROCEDURE
To set up the SPEED CALLING-SYSTEM:
1. Depress the idle
LOOP
key.
2. Depress the
PROG
key.
The
PROG
key LED (red) lights.
“
PASSWORD
” is displayed on the LCD as prompt information.
3. Dial the password (1-8 digits).
The dialed password is displayed on the LCD.
When the password dialing is completed, the
PROG
key LED (red) blinks at this time.
If the
RLS
key is depressed in this status, the Attendant Console can go back to the idle status.
At this time, both
CANCEL
and
ANS
keys are invalid.
After the above operation, select; SPD operation.
4. Depress the
SPD
key.
The
SPD
key LED (red) comes on.
5. Dial the block # (5 digits).
The selected block number is displayed as follows along with the currently registered trunk access
code and telephone number.
000012..........0-
12345............56
SPD
6. Dial the new trunk access code to register.
If there is no change, skip to step 4.
7. Depress the
ANS
key.
8. Dial the new telephone number.
If there is no change, skip to step 6.
9. Depress the
ANS
key.
The new access code and the telephone number are set up.
10. Depress the
CNCL
key.
To program another block number, return to step 2.
11. Depress the
CNCL
key.
The system goes back to the status assumed after the password was set.