NEC NEAX 2000, Руководство по программированию

Страница: 1055 / 1200

ND-91285-001(E)
DECEMBER, 1999
Page 273
Revision 1.0
(1/1)
PEG COUNT
GENERAL DESCRIPTION
This service feature permits traffic studies and traffic analysis information to be accessed from the
MAINTENANCE ADMINISTRATION TERMINAL (MAT) and CUSTOMER ADMINISTRATION
TERMINAL (CAT).
OPERATING PROCEDURE
Refer to the Command Manual.
SERVICE CONDITIONS
1. All information required for this feature is registered at the MAINTENANCE ADMINISTRATION
TERMINAL (MAT).
2. The following information can be accessed:
• Number of successful attempts at outgoing access, based on trunk route.
• Number of times all trunks were busy, based on trunk route.
• Number of incoming calls, based on trunk route.
• Number of incoming calls connected to busy tone and then trunk abandoned.
• Quantity of incoming calls with no answer and trunk abandoned, based on trunk route.
• Number of times a push button register was connected, on a system basis.
• Number of times all push button registers were busy, on a system basis.
• Number of outgoing connections using modem trunks, based on modem trunk group.
• Number of incoming connections using modem trunks, based on modem trunk group.
• Number of times all modem trunks were busy, based on modem trunk group.
• Number of times the CONFERENCE circuits were used, on a system basis.
• Number of times CONFERENCE circuits were all busy, on a system basis.
• Number of times an incoming call was CALL FORWARDED-DON’T ANSWER to the Attendant
or another station (on DID, Tie or DIT lines), on a system basis.
• Number of Tandem Connections, on a system basis.
• Number of times a push button register was connected to a trunk, based on trunk route.
• Number of Attendant calls including recalls, on a system basis.
• Number of station-to-station calls, on a system basis.
• Number of times senders were all busy, on a system basis.
• Number of ring generator capacity overflows, on a system basis.
• Number of DTE to DTE connections, on a system basis.
(UCD Peg Count)
• Number of answered calls by UCD group.
• Number of incoming calls by UCD group.
• Number of waiting calls for a pre-determined time into queuing mode on the UCD group.
• Number of incoming calls to all busy stations in the UCD group.
• Number of answered calls in the UCD group.
3. The above information may be registered and cancelled as required.