NEC NEAX 2000, Руководство по программированию

Страница: 346 / 1200

– 326 –
A2325-10
MESSAGE CENTER INTERFACE (MCI)
PROGRAMMING
AP Initialization
AP Initialization
This section explains the data assignment to make the AP active. If the system already applied
the AP related feature, you can skip the data assignment explained on this section.
The AP should have already activated if one of the following feature applied; SMDR (Station Mes-
sage Detail Recording), MCI (Message Center Interface), D
term
TIMS (Time Information Man-
agement System), PMS (Property Management System), or Hotel printer.
You can distinguish whether the AP active or not by the RUN lamp indication. The RUN lamp
flashes on green color when the AP is in active.
When you install the AP00 at first time, you should assign the data shown below.
DESCRIPTION DATA
Assign an AP number to the AP00 card.
The AP number must match the SENSE
switch setting on the AP00 card.
On the AP00 card, set SW1 switch as
shown below.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
04: AP00 card
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
START
CM05
A
INITIAL
SW1
ON
: POSITION TO BE SET
4
3
2
1