Mitsubishi Electric Melservo-J3 Series MR-J3-B, Инструкция по эксплуатации

Страница: 704 / 802

17 - 19
17. SPEED CONTROL OPERATION
Code No. Item/Function
Reading data (RW
rn
+3) contents
(Servo amplifier
→
programmable controller)
0701h
to
0702h
Acceleration time constant of point table No.1 and
2. The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. The acceleration time constant set in the requested point table No. is
returned.
0801h
to
0802h
Deceleration time constant of point table No.1 and
2. The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No.
The deceleration time constant set in the requested point table No. is
returned.
(2) Write instruction codes
The data requested to be written with the instruction code 8010h to 91FFh is written to the servo amplifier.
Set the instruction code No. corresponding to the item to the instruction code (RWwn+2) and the data to be
written to the writing data (RWwn+3). The codes and return data are represented in 4-digit hexadecimal
numbers.
When an instruction code No. that is not described in this section is set, an error code (
□□
1
□
) is stored to the
respond coder (RWrn+2).
Code No. Item
Writing data (RW
wn
+3) contents
(Programmable controller
→
servo amplifier)
8010h Alarm reset command
Deactivates the alarm that occurred. 1EA5
8101h Feedback pulse value display data clear command
Resets the display data of the status indication
"Cumulative feedback pulse" to 0. 1EA5
8200h Writing parameter group command
Writes the group of parameters that are written to
with codes No.8201h to 82FFh and 8301h to
83FFh.
Writes the group of parameters that are read with
codes No.0201h to 02FFh and 0301h to 03FFh.
0 0 0
Parameter group
0: Basic setting parameters (No.PA )
1: Gain/filter parameters (No.PB )
2: Extension setting parameters (No.PC )
3: I/O setting parameters (No.PD )
8201h
to
82FFh
Data RAM command of parameter
Writes the set value of each No. of the parameter
group written by code No.8200h to RAM. The value
is cleared when power is switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the parameter
No.
An error code is returned if an instruction code
outside the range set in parameter No.PA19 or a
value outside the setting range of the corresponding
parameter is written. Convert the decimal values into hexadecimal before setting.
8301h
to
83FFh
Data EEP-ROM command of parameter
Writes the set value of each No. of the parameter
group written by code No.8200h to EEP-ROM.
Since the value is written to EEP-ROM, the value is
held if power is switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the parameter
No.
An error code is returned if an instruction code
outside the range set in parameter No.PA19 or a
value outside the setting range of the corresponding
parameter is written. Convert the decimal values into hexadecimal before setting.