Mitsubishi Electric Melservo-J3 Series MR-J3-B, Инструкция по эксплуатации, Страница: 705 / 802

17 - 20
17. SPEED CONTROL OPERATION
Code No. Item
Writing data (RW
wn
+3) contents
(Programmable controller
→
Servo amplifier)
8601h
to
8608h
Servo motor speed data RAM command of point
table
Writes the servo motor speed of point table No. 1 to
8 to RAM. These values are cleared when power is
switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. Convert the values into hexadecimal before setting.
8701h
to
8702h
Acceleration time constant data RAM command of
point table
Writes the acceleration time constants of point
table No.1 and 2 to RAM. These values are cleared
when power is switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. Convert the values into hexadecimal before setting.
8801h
to
8802h
Deceleration time constant data RAM command of
point table
Writes the deceleration time constants of point
table No.1 and 2 to RAM. These values are cleared
when power is switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. Convert the values into hexadecimal before setting.
8D01h
to
8D08h
Servo motor speed data EEP-ROM command of
point table
Writes the servo motor speed of point table No.1 to
8 to EEP-ROM. The values are written to
EEP-ROM and therefore stored even if the power is
switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. Convert the values into hexadecimal before setting.
8E01h
to
8E02h
Acceleration time constant data EEP-ROM
command of point table
Writes the acceleration time constant No. of point
table No.1 and 2 to EEP-ROM. The values are
written to EEP-ROM and therefore stored even if
the power is switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. Convert the values into hexadecimal before setting.
8F01h
to
8F02h
Deceleration time constant data EEP-ROM
command of point table
Writes the deceleration time constants of point
table No.1 and 2 to EEP-ROM. The values are
written to EEP-ROM and therefore stored even if
the power is switched off.
The decimal value converted from the lower two
digits of the code No. corresponds to the point table
No. Convert the values into hexadecimal before setting.