Mitsubishi Electric Melservo-J3 Series MR-J3-B, Инструкция по эксплуатации

Страница: 400 / 802

13 - 3
13. CHARACTERISTICS
13.2 Power supply equipment capacity and generated loss
(1) Amount of heat generated by the servo amplifier
Table 13.1 indicates servo amplifiers' power supply capacities and losses generated under rated load. For
thermal design of an enclosure, use the values in Table 13.1 in consideration for the worst operating
conditions. The actual amount of generated heat will be intermediate between values at rated torque and
servo-off according to frequency of operation. When the servo motor is run at less than the maximum
speed, the power supply capacity will be smaller than the value in the table, but the servo amplifier's
generated heat will not change.
Table 13.1 Power supply capacity and generated heat per servo amplifier at rated output
Servo amplifier Servo motor
(Note 1)
Power supply
capacity [kVA]
(Note 2)
Servo amplifier-generated heat[W]
Area required for
heat dissipation
[m
2
] At rated torque
At rated output
[Generated heat in the
cabinet when cooled
outside the cabinet]
(Note 5)
With servo off
MR-J3-10T (1)
HF-MP053 0.3 25 15 0.5
HF-MP13 0.3 25 15 0.5
HF-KP053 13 0.3 25 15 0.5
MR-J3-20T (1)
HF-MP23 0.5 25 15 0.5
HF-KP23 0.5 25 15 0.5
MR-J3-40T (1)
HF-MP43 0.9 35 15 0.7
HF-KP43 0.9 35 15 0.7
MR-J3-60T (4)
HF-SP52 (4) 1.0 40 15 0.8
HF-SP51 1.0 40 15 0.8
HC-LP52 1.0 40 15 0.8
HF-JP53 (4) 1.0 40 15 0.8
MR-J3-70T
HF-MP73 1.3 50 15 1.0
HF-KP73 1.3 50 15 1.0
HC-UP72 1.3 50 15 1.0
HF-JP73 1.3 50 15 1.0
MR-J3-100T (4)
HF-SP102 (4) 1.7 50 15 1.0
HF-SP81 1.5 50 15 1.0
HC-LP102 1.7 50 15 1.0
HF-JP734 1.3 50 15 1.0
HF-JP103 (4) 1.7 50 15 1.0
MR-J3-200TN
200T4
HF-SP152 (4) 2.5 90 20 1.8
HF-SP202 (4) 3.5 90 20 1.8
HF-SP121 2.1 90 20 1.8
HF-SP201 3.5 90 20 1.8
HC-RP103 1.7 50 15 1.0
HC-RP153 2.5 90 20 1.8
HC-UP152 2.5 90 20 1.8
HC-LP152 2.5 90 20 1.8
HF-JP153 (4) 2.5 90 20 1.8
HF-JP203 (4) 3.5 90 20 1.8