Mitsubishi Electric Melservo-J3 Series MR-J3-B, Инструкция по эксплуатации

Страница: 269 / 802

6 - 28
6. PARAMETERS
No. Symbol Name and function Initial value Unit Setting range
PC37 *LPPL Position range output address
Used to set the address increment side position range output address. Set
the same sign to parameters No.PC37 and PC38. Setting of different signs
will result in a parameter error.
In parameters No.PC37 to PC40, set the range where position range (RXnE)
turns on.
Set address:
Upper 3
digits
Lower 3
digits
Parameter No.PC38
Parameter No.PC37
Position range output address is a set of upper digits and lower digits. To
change the value, set in the order of lower digits to upper digits.
0 10 STM m 999999
to
999999
PC38 *LPPH
PC39 *LNPL Position range output address
Used to set the address decrement side position range output address. Set
the same sign to parameters No.PC39 and PC40. Setting of different signs
will result in a parameter error.
Set address:
Upper 3
digits Lower 3
digits
Parameter No.PC39
Parameter No.PC40
Position range output address is a set of upper digits and lower digits.
To change the value, set in the order of lower digits to upper digits.
0 10
STM
m
999999
to
999999
PC40 *LNPH
PC41 For manufacturer setting 0000h
PC42 Do not change this value by any means. 0000h
PC43 0000h
PC44 0000h
PC45 0000h
PC46 0000h
PC47 0000h
PC48 0000h
PC49 0000h
PC50 *COPA Function selection C-A
0 0 0
CC-Link communication error (A8D)
extended function selection
0: No extended function
1: CC-Link communication error (A8D) detection delay
Use parameter No.PD25 to set how long to delay the
occurrence timing of CC-Link communication error (A8D).
This parameter is available with servo amplifiers with software version A8
or later.
When this parameter is set using MR Configurator with software version C5
or earlier, the parameter name is not displayed. However, the setting value
is changeable. Follow the instructions in this Instruction Manual to set the
value.
0000h Refer to
name and
function
column.