Mitsubishi Electric Melservo-J3 Series MR-J3-B, Инструкция по эксплуатации

Страница: 735 / 802

17 - 50
17. SPEED CONTROL OPERATION
No. Symbol Name and function
Initial
value
Unit
PC43 For manufacturer setting 0000h
PC44 0000h
PC45 Not used in speed control operation. 0000h
PC46 Do not change the parameter. 0000h
PC47 0000h
PC48 For manufacturer setting 0000h
PC49 0000h
PC50 *COPA Function selection C-A 0000h Refer to the
Name and
function column.
(2) Detail list
No. Symbol Name and function
Initial
value
Unit
Setting
Range
PC01 For manufacturer setting
Do not change this value by any means.
0000h
PC02 Not used in speed control operation. 0000h
PC03
Do not change the parameter.
0001h
PC04 500
PC05 10
PC06 0
PC07 0
PC08 1000
PC09 100
PC10 15.0
PC11 0
PC12 100
PC13 *STC S-pattern acceleration/deceleration time constant
Set this parameter to insert S-pattern acceleration/deceleration time
constants for the acceleration/deceleration time constants of the point table.
(Refer to section 6.3.3.)
0 ms 0
to
1000
PC14 Not used in speed control operation.
Do not change the parameter.
0
PC15 For manufacturer setting
Do not change this value by any means.
0000h
PC16 MBR Electromagnetic brake sequence output
Set a delay time (Tb) from when the electromagnetic brake interlock (MBR)
is turned off until when the base circuit is shut-off.
100 ms 0
to
1000
PC17 ZSP Zero speed
Set the output range of the zero speed detection (ZSP).
The zero speed detection (ZSP) has a hysteresis width of 20 r/min.
(Refer to section 17.2.2 (2).)
50 r/min 0
to
10000
PC18 *BPS Alarm history clear
This parameter is used to clear the alarm history.
0 0 0
Alarm history clear
0: Invalid
1: Valid
When alarm history clear is made valid,
the alarm history is cleared at next power-on
After the alarm history is cleared, the setting
is automatically made invalid (reset to 0).
0000h Refer to
the
Name
and
function
column.