Mitsubishi Electric Melservo-J3 Series MR-J3-B, Инструкция по эксплуатации

Страница: 703 / 802

17 - 18
17. SPEED CONTROL OPERATION
Code No. Item/Function
Reading data (RW
rn
+3) contents
(Servo amplifier
→
programmable controller)
0100h
to
011Dh
Monitor multiplying factor
Reads the multiplying factor of the data to be read
with the monitor code.
The instruction codes 0100 to 011D correspond to
the monitor codes 0000 to 001D.
0000h is applied to the instruction code that does
not correspond to the monitor code.
Monitor multiplying factor
0003: ×1000
0002: ×100
0001: ×10
0000: ×1
0200h Parameter group reading
Reads the parameter group that is written with
code No.8200h.
0 0 0
Parameter group
0: Basic setting parameters (No.PA )
1: Gain/filter parameters (No.PB )
2: Extension setting parameters (No.PC )
3: I/O setting parameters (No.PD )
0201h
to
02FFh
Parameter data reading
Reads the set value of each No. of the parameter
group read with code No.0200h.
The values of the last 2 digits of the code No. are
converted to decimal, and the decimal value
corresponds to the parameter No.
If the instruction code is set outside the range set
in parameter No.PA19, an error code is returned
and the data cannot be read. The value set in the parameter No. corresponding to the requested
parameter group is stored.
0301h
to
03FFh
Data format of parameter
Reads the data format of each No. of the
parameter group read with code No.0200h.
The values of the last 2 digits of the code No. are
converted to decimal, and the decimal value
corresponds to the parameter No.
If the instruction code is set outside the range set
in parameter No.PA19, an error code is returned
and the data cannot be read. The value set in the parameter No. corresponding to the requested
parameter group is stored.
0
Data format
0: Used unchanged as hexadecimal.
1: Must be converted into decimal
Parameter writing type
0: Valid after being written
1: Valid when power is switched on again
after being written
Decimal point position
0: Without decimal point
1: Last digit (Without decimal point)
2: Second last digit
3: Third last digit
4: Forth last digit
0601h
to
0608h
The decimal value converted from the lower two
digits of the servo motor speed code No. in the
point table No. 1 to 8 corresponds to the point
table No. The servo motor speed set in the requested point table No. is returned.
Servo motor speed