VM-214DT
Quick Start
P/N:
2 9 0 0 - 3 0 0 5 7 0 QS
Rev:
3
Scan for full manual
VM-214DT Quick Start Guide
This guide helps you install and use your
VM-214DT
for the first time.
Go to
www.kramerav.com/downloads/VM-214DT
to download the latest user manual and check if firmware
upgrades are available.
Step 1:
Check what’s in the box
VM-214DT
HDMI/HDBT Switcher/DA
1 Quick start guide
1 Set of rack ears
1 Power cord
4 Rubber feet
Step 2: Get to know your VM-214DT
#
Feature
Function
1
IR LED
Lights orange when the unit accepts IR remote commands.
2
IR Sensor
Extends a detected IR signal to the connected HDBT devices as defined in the Data
Switching embedded web page
– when an IR sensor is
not connected
to the IR 3.5mm mini
jack on the rear panel.
Disabled when the IR 3.5mm mini jack on the rear panel is connected.
3
POWER LED
Lights when the unit is powered.
4
VOLUME (
)
Press to decrease the volume of the analog audio output.
5
VOLUME (
)
Press to increase the volume of the analog audio output.
6
INPUT Selector Button
Press to select input 1 HDMI or input 2 HDBT.
7
HDMI / HDBT INPUT LED
Lights green to indicate that the HDMI 1 / HDBT 2 input is selected.
8
EDID READ Button
Press to read the selected EDID and write it to both inputs.
9
EDID SELECT Button
Press to cycle through the sources from which to read the EDID: Default, External, or Output.
When Output is selected, cycles through outputs 1 to 9. The relevant EDID TYPE and
OUTPUT LEDs light green.
10
EDID TYPE LEDs
Lights green to indicate that the DEFAULT EDID / EXT. (external) EDID / OUTPUT EDID is
selected.
11
OUTPUT LEDs (1 to 5)
In normal operation mode: lights green when an acceptor is connected to the output.
In EDID mode: when EDID TYPE OUTPUT LED lights green, press the EDID SELECT button
briefly to cycle through output 1 to 9 to select the output from which to read EDID. The
relevant LED lights during EDID setup and remains lit after completing the EDID setup.
