Mitsubishi Electric MELSEC Q Series, Руководство пользователя

Страница: 469 / 834

9 - 69
Chapter 9 Major Positioning Control
Positioning data setting examples
[When "2-axis circular interpolation control with center point designation (ABS
circular right, ABS circular left)" is set in positioning data No. 1 of axis 1]
• Reference axis ............. Axis 1
• Interpolation axis.......... Axis 2 (The required values are also set in positioning
data No. 1 of axis 2.)
Axis
Setting item
Setting example
Setting details
Axis 1
(reference
axis)
Axis 2
(interpolation
axis)
A
xi
s 1
P
os
iti
oni
ng dat
a No.
1
[Da.1] Operation pattern
Positioning
complete
–
Set "Positioning complete" assuming the next
positioning data will not be executed.
[Da.2] Control method
ABS circular
right
ABS circular
left
–
Set absolute system, 2-axis circular
interpolation control with center point
designation. (Select clockwise or
counterclockwise according to the control.)
[Da.3] Acceleration time No. 1 –
Designate the value set in "[Pr.25]
Acceleration time 1" as the acceleration time
at start.
[Da.4] Deceleration time No. 0 –
Designate the value set in "[Pr.10]
Deceleration time 0" as the deceleration time
at deceleration.
[Da.6]
Positioning address/
movement amount
8000.0

m 6000.0

m
Set the positioning address. (Assuming "mm"
is set in "[Pr.1] Unit setting".)
[Da.7] Arc address 4000.0

m 3000.0

m
Set the arc address (center point address).
(Assuming that the "[Pr.1] Unit setting" is set to
"mm".)
[Da.8] Command speed
6000.00
mm/min
–
Set the speed when moving to the end point
address. (Designate the composite speed in
"[Pr.20] Interpolation speed designation
method".)
[Da.9]
Dwell time/JUMP
destination positioning
data No.
500ms –
Set the time the machine dwells after the
positioning stop (command stop) to the output
of the positioning complete signal.
[Da.10]
M code/Condition data
No./Number of LOOP
to LEND repetitions
10 –
Set this when other sub operation commands
are issued in combination with the No.1
positioning data.
[Da.20]
Axis to be interpolated
No.1
Axis 2 –
Set the axis to be interpolated.
If the self-axis is set, an error will occur.
[Da.21]
Axis to be interpolated
No.2
– –
Setting not required (setting value is ignored).
[Da.22]
Axis to be interpolated
No.3
– –
(Note): Refer to Section 5.3 "List of positioning data" for information on the setting details.
POINT
Set a value in "[Da.8] Command speed" so that the speed of each axis does not
exceed the "[Pr.8] Speed limit value". (The speed limit does not function for the
speed calculated by the Simple Motion module during interpolation control.)