Mitsubishi Electric MELSEC Q Series, Руководство пользователя

Страница: 699 / 834

13 - 95
Chapter 13 Control Sub Functions
[2] Precautions during control
(1) The time required to analyze the positioning data is up to one operation cycle.
(2) After positioning data analysis, the system is put in an execution prohibition
flag OFF waiting status. Any change made to the positioning data in the
execution prohibition flag OFF waiting status is not reflected on the
positioning data. Change the positioning data before turning ON the
positioning start signal.
(3) The pre-reading start function is invalid if the execution prohibition flag is
turned OFF between when the positioning start signal has turned ON and
when positioning data analysis is completed (Ta<start time, Ta: Refer to Fig.
13.48).
(4) The data No. which can be executed positioning start using "[Cd.3]
Positioning start No." with the pre-reading start function are No. 1 to 600 only.
Performing the pre-reading start function at the setting of No. 7000 to 7004 or
9001 to 9004 will result in the error "Outside start No. range" (error code: 543).
(5) Always turn ON the execution prohibition flag at the same time or before
turning ON the positioning start signal. Pre-reading may not be started if the
execution prohibition flag is turned ON during Ta after the positioning start
signal is turned ON. The pre-reading start function is invalid if the execution
prohibition flag is turned ON after positioning start with the execution
prohibition flag OFF. (It is made valid at the next positioning start.)
[3] Program examples
[Program example]
U0\
G2417.D
Pre-reading start program (when positioning start signal Y10 is used)
<Pre-reading start command pulse>
<Sets 1 to positioning start No.>
<Turns ON execution prohibition flag>
<Turns ON positioning start signal>
<Turns OFF execution prohibition flag>
<Turns OFF positioning start signal>
M100 PLS
0
11
26
X4B
33
45
Y10
X4C
M100
Y10
DX10
Y10 SET
Y10 RST
END
H0 TOP K4300 K1 K1
Use the direct access input as BUSY
signal to use this program example.
U0\
G2417.E
U0\
G2417.E
H0 TOP K30103 K1 K1
H0 TOP K30103 K0 K1