Mitsubishi Electric MELSEC Q Series, Руководство пользователя

Страница: 258 / 834

5 - 138
Chapter 5 Data Used for Positioning Control
Setting item Setting details
[Cd.12] Acceleration/deceleration time
change value during speed
change, enable/disable

Enables or disables modifications to the acceleration/deceleration time during a
speed change.
Fetch cycle: At change request
[Cd.13] Positioning operation speed
override

To use the positioning operation speed override function, use this data item to
specify an "override" value.
: For details of the override function, refer to Section 13.5.2 "Override function".
If the command speed is set to less than the minimum unit using the override
function, the speed is raised to the minimum unit and the warning "Less than
minimum speed" (warning code: 110) occurs.
Fetch cycle: Operation cycle
[Cd.14] New speed value

When changing the speed, use this data item to specify a new speed.

The operation halts if you specify "0".

The setting value range differs according to the "[Pr.1] Unit setting".
[Pr.1] Unit
setting
mm
(

10
-2
mm/min)
inch
(

10
-3
inch/min)
degree
(

10
-3
degree/min)
PLS
(PLS/s)
Setting range
0 to
2000000000
0 to
2000000000
0 to
2000000000
0 to
1000000000
: When "[Pr.83] Speed control 10 x multiplier setting for degree axis" is valid,
this will be the setting range 0 to 2000000000 (

10
-2
degree/min).
Fetch cycle: At change request
[Cd.15] Speed change request

After setting the "[Cd.14] New speed value", set this data item to "1" to execute
the speed change (through validating the new speed value).
Fetch cycle: Operation cycle