Mitsubishi Electric MELSEC Q Series, Руководство пользователя

Страница: 793 / 834

16 - 47
Chapter 16 Troubleshooting
Related buffer memory address
Set range
(Setting with sequence program)
Remedy
— — Switch the control mode after turning BUSY OFF.
— —
Switch the control mode after turning "Zero speed"
([Md.108] Servo status) ON.
4375+100n
<Control mode setting>
0, 10, 20
Switch the control mode after setting a value within the
range for "[Cd.139] Control mode setting".
— —
Carry out the control mode switching request after
completing the control mode switching.
54000+20k
< Mark detection signal setting >
0 to 16
Set a value within the setting range.
54002+20k
< Mark detection data type >
-1 to 12
54003+20k
< Mark detection data axis No.>
1 to 16, 801 to 804
Set a value within the setting range.
54004+20k
54005+20k <Mark detection data buffer memory No.>
0 to 65534
Set a value with an even number within the setting
range.
JOG speed <JOG speed>
1 to 1000000000 [PLS/s]
1 to 2000000000 [ 10
-2
mm/min or another]
Do not carry out the JOG speed change during
deceleration with the JOG start signal OFF.
4318+100n
4319+100n
New speed value <New speed value>
0 to 1000000000 [PLS/s]
0 to 2000000000 [ 10
-2
mm/min or another]
Set a value within the setting range.
4314+100n
4315+100n
JOG speed limit value
<JOG speed limit value>
1 to 1000000000 [PLS/s]
1 to 2000000000 [ 10
-2
mm/min or another]
48+150n
49+150n
Positioning operation speed override
< Positioning operation speed override >
1 to 300 [%]
4313+100n
4322+100n
4323+100n
<Manual pulse generator 1 pulse input
magnification>
1 to 1000
Set the manual pulse generator 1 pulse input
magnification to within the setting range.
n: Axis No.-1
k: Mark detection setting No.-1