Mitsubishi Electric E70 Series, Инструкция по эксплуатации

Страница: 686 / 782

E70 Series Instruction Manual
Appendix 7.8 Measurement-related Operation Messages
IV - 153
Appendix 7.8 Measurement-related Operation Messages
Message Details
TLM switch OFF
- Measurement, retrieving of the skip position, writing the coordinates data etc.
was attempted when the TLM switch was OFF.
Can't take-in skip posn
- Could not retrieve the skip position.
Check the following:
< When measuring the workpiece >
1. Is the name of the axis to be measured designated in the basic axis(I, J, K)?
2. Is the axis that executed the axis movement a measurement axis?
< When measuring the rotation >
1. Is the name of the axis to be measured designated in the coordinate rotation
plane (horizontal axis, vertical axis)?
2. Is the axis that executed the axis movement a measurement axis?
Can't write coordinates data
- Could not obtain the measured axis No.
- The measured angle was illegal.
- Could not write into the coordinate system offset.
Measure again.
- The work coordinate offset data was attempted to set when the measurement
counter does not have the necessary values.
- The work coordinate offset date was attempted to set in the slave axis.
Sensor take in not possible
- Could not retrieve the position measured with the touch sensor.
Measure again.
Can't measure - Measurement failed.
Sensor signal was illegally turned on
- The sensor signal was already ON when the tool measurement mode (TLM)
signal was validated.
- The sensor signal turned ON when there was no axis movement after the tool
measurement mode (TLM) signal was validated.
- The sensor signal turned ON at a position within 100
μ m from the final entry start
position.
- Move the axis in a safe direction after turning the sensor signal OFF or turning
the tool measurement mode signal OFF.
Can't write compensation data
- The cursor position and the cell for writing the compensation amount (length
dimension, radius dimension) do not match.
Match the cursor position with the cell for writing the compensation amount.
Offset No. not found
- During manual tool length measurement, the sensor was turned ON designating
tool offset No. not exist.
- During manual tool length measurement, the measurement method was
switched to manual tool length measurement 2 designating tool offset No. not
exist.
- Correctly set the R register of offset No.
TLM axis is illegal
- During 2 or more axes movement, the tool length measurement was executed
by turning the sensor ON. Keep the tool away from the sensor and execute the
measurement by one axis.
TLM axis not returned to ref. position
- The tool length measurement was executed by tuning the sensor ON for the axis
in which dog-type reference point return has not been executed. Carry out
reference point return for the measurement axis.
Can't write rotation parameter - The measured result cannot be set in the process parameter.