Mitsubishi Electric E70 Series, Инструкция по эксплуатации, Страница: 717 / 782

Appendix 8 User Parameters
MITSUBISHI CNC
IV - 184
【 #8084 】 G83S Clearance (for M system only)
Set the clearance amount for the small diameter deep hole drilling cycle (G83).
---Setting range---
0 to 999.999 (mm)
【
#8085
】
G83S Forward F (for M system only)
Set the feedrate from the R point to the cutting start position in the small diameter deep hole drilling
cycle (G83).
---Setting range---
0 to 99999 (mm/min)
【
#8086
】
G83S Back F (for M system only)
Set the speed for returning from the hole bottom during the small diameter deep hole drilling cycle
(G83).
---Setting range---
0 to 99999 (mm/min)
【
#8090
】
SSS ON (for M system only)
Set whether to enable the SSS control with G05 P10000.
0: Disable
1: Enable
【
#8091
】
StdLength (for M system only)
Set the maximum value of the range for recognizing the shape.
To eliminate the effect of steps or errors, etc., set a large value. To enable sufficient deceleration, set
a small value.
If "0.000" is set, the standard value (1.000mm) will be applied.
---Setting range---
0 to 100.000 (mm)
【
#8092
】
ClampCoeff (for M system only)
Set the clamp speed at the curved section configured of fine segments.
Coefficient =
√
setting value
---Setting range---
1 to 100
【
#8093
】
StepLeng (for M system only)
Set the width of the step at which the speed is not to be decelerated. (Approximately the same as the
CAM path difference [Tolerance].)
If "0" is set, the standard value (5
μ
m) will be applied.
If a minus value is set, the speed will decelerate at all minute steps.
---Setting range---
-1.000 to 0.100 (mm)
【 #8094 】 DccWaitAdd (for M system only)
Set the time to wait for deceleration when the speed FB does not drop to the clamp speed.
---Setting range---
0 to 100 (ms)
【
#8101
】
MACRO SINGLE
Select how to control the blocks where the user macro command continues.
0: Do not stop while macro blocks continue.
1: Stop every block during signal block operation.