Mitsubishi Electric E70 Series, Инструкция по эксплуатации

Страница: 680 / 782

E70 Series Instruction Manual
Appendix 7.2 Graphic Display-related Operation Messages
IV - 147
Appendix 7.2 Graphic Display-related Operation Messages
Message Details
Searching - The check search is being executed.
Search error
- Could not find the designated ONB number.
Review the ONB number or machining program settings.
- The check search could not be completed correctly.
- When the parameter (#9005) of the tape mode port was set out of the range or
when the port was not connected, an operation search of NC serial was
performed.
Executing automatic operation
- An attempt was made to perform operations such as parameter, tool
compensation amount data and coordinate system offset settings during
automatic operation. (Input/output also possible during automatic operation)
- The machining program and MDI data that the operator is attempting to edit
cannot be edited during automatic operation.
- It is not possible to be executed a check search or check start-up during
automatic operation.
- An attempt was made to set the verify stop position during automatic operation.
Setting error
- The directory name exceeded the display range.
A directory path for which the entire directory cannot be displayed cannot be
designated in the directory name area.
- The check search is not possible because ONB number is not designated.
- A non-existent axis name or setting that does not exist in the format was made
when making the display mode settings.
Set using an existing axis name.
- Incorrect tool No. was specified at the execution of tool clear.
Execute operation search
- The program is not searched.
Execute the operation search.
Checking - The program check is being executed.
Check stopped - The program check is being stopped.
Work form is illegal
- A workpiece is not drawn correctly because the two or more workpiece widths
are set to "0".
Push [Check reset] menu
- An error occurred in the graphic check.
Press the [Check reset] menu key to reset the error.
Executing trace - The trace mode is valid.
Program check completed - The trace in the program check completed with an M02/M30 code.
Reset complete - The program check was reset.
Tool interfere with work
- The tool contacted the workpiece when performing rapid traverse (G0)
movement with the interference check enabled.
Program checking - The program check is being executed.
Executing reset operation - The program check is being reset.
Executing trace(tip posn) - The tip position trace mode is valid.
Executing BG simulation - The back ground simulation is being executed.
Draw library inside error (n) - Contact the service center.
Program check not possible - Graphic check was attempted during the Computer link B operation.
Execute check search - The program check is disabled. Execute the check search.
Solid check disabled (memory shortage)
- The 3D program check is disabled due to the memory shortage.
Separate the programs and execute the check drawing again.
Press the menu [Work init] once before performing the check drawing again.
Executing scale Scale is being automatically adjusted.