Mitsubishi Electric E70 Series, Инструкция по эксплуатации

Страница: 133 / 782

2 Monitor Screens
MITSUBISHI CNC
I - 108
(5) Previous command and command in execution
(a) When the buffer is corrected following the operation mode change at single block stop, nothing will be
displayed in previous command and command in execution.
(b) When there is no block after sub program call or user macro call, a program error occurs at the last block of the
destination program. If a buffer correction is made in this state, the destination program will be displayed in the
buffer correction window, but the actual correction result will be reflected on the source program.
(c) The buffer cannot be corrected when the block where the buffer is corrected is in the forward side from the
block called at another nest level. The operation message "Buffer correct not possible" appears. The buffer
can be corrected when the block where the buffer is corrected is in the rear side from the block called at
another nest level.
•
•
M98 H 111
M30
•
•
N999
G00 X10.
G04
Z20.
G04.
Y30.
G04.
M99
•
•
N111
N112 G00 X5.0
M98 H999
M21
G01 X100.
•
•
(a)
(c)
(b)
(d)
(a) : The buffer can be corrected.
(b)(d) : The buffer can be corrected
because the block is in the
rear side from (a).
(c) : The buffer cannot be corrected
because the block is in the
forward side from (b).