Mitsubishi Electric E70 Series, Инструкция по эксплуатации

Страница: 335 / 782

5 Diagnosis Screens
MITSUBISHI CNC
I - 310
(Note) Decimal, hexadecimal, floating point data and character string data writing is possible.
Note that hexadecimal, floating point data and character strings may not be settable depending on the data.
Menus
Menu Details Type Reference
This erases the information in the line where the cursor is. (One entire line
becomes blank.) The cursor does not move at this time.
C
The contents of the set address data (Part system No, Section/sub-
section/axis) for all the lines are constantly displayed.The Index No.
highlight (indicating data is being set) is released.The cursor appears in
"Part system No" of that line.
C
5.5.1 Writing/Reading
the Data Using the NC
Data Designation
This writes the data (Note) in the setting area to the NC memory indicated
by address data at the cursor position.The Data No. highlight (indicating
data is being set) is released, and constant display is started.After writing,
the cursor moves to "Part system No" of the next line.
A
Based on the data of the address data where the cursor is, this displays the
continuous data to which the sub-section No. has been added to the
address data from the line where the cursor is.The cursor moves to "Part
system No " of that line.
C
Based on the data of the address data where the cursor is, this displays the
continuous data to which the axis No. has been added to the address data
from the line where the cursor is.The cursor moves to "Part system No " of
that line.
C
Decimal : Integers without decimal points …(Example) -1234
Hexadecimal : An "H" is necessary at the end …(Example) 1234H
Floating point data : Data with a decimal point … (Example) -12.3
Character string data : Character string……………… (Example) X
Line
clear
Data
read
Data
write
Subsect
continu
Axis
continu