Hudson 1948 - 1952, Руководство по обслуживанию

Страница: 57 / 333

FIGURE 16
3. Install upper and lower bearing shells. CAUTION: Do
not file bearing shells or bearing caps.
4. Tighten all bearing cap bolts to 70-80 foot pounds with
J-1264 torsion wrench.
After Installation of new bearing shells, check crank-
shaft end play which should be .003 minimum to .009
maximum.
5. Install wick packing into the vertical holes (1) and (2) in
front and rear caps first, Figure 16, then into the horizon-
tal holes (3) of the front bearing cap, Figure 17.
FIGURE 17
NOTE: When Installing new packing, use a blunt punch
with a diameter slightly smaller than the packing groove.
Punch end should be not shorter than 4 inches to insure
seal bottoming.
Packing must be compressed until it bottoms in the pack-
ing grooves, and enough packing Installed to make a solid
seal flush with front face and bottom face of the bearing
caps.
MAIN BEARINGS
(8 Cylinder)
NOTE: To determine shell thickness proceed as follows:
1. Add the diametral clearance to the crankshaft diameter.
2. Subtract the total from the block bore diameter.
3. Divide the answer by two to determine the thickness of
the bearing shell
*EXAMPLE:
2.280 Crankshaft
+ 0.001 Diametral Clearance
2.281 TOTAL
2.6535 Bore Diameter
- 2.2810
+ 2/0.3725
0.18625 Thickness of bearing shell
REMOVAL:
The upper and lower main bearing shells are each held
in place in the crankcase and bearing caps with slotted flat
brass machine screws.
ENGINE 3 - 15
EIGHT CYLINDER MAIN BEARING CLEAR-
ANCE, CRANKSHAFT AND BORE DIAMETERS:
BEAR-
ING
NUMBER
DIMETRAL
CLEAR-
ANCE
CRANK
SHAFT
DIAMETER
BORE
DIAME-
TER
No. 1
No. 2
No. 3
No. 4
No. 5
*.001
.001
.001
.001
.001
*2.280
2.312
2.342
2.374
2.405
*2.6535
2.6550
2.6855
2.687
2.7155
2.7170
2.7475
2.7490
2.7785
2.7800