Guardall Windsor 500, Руководство по программированию

Страница: 94 / 108

Windsor 500 Programming Manual - Issue C
- 94 -
Edit page 3
Detector
Windsor can be programmed to test circuits programmed as detector circuits (Det). The
detector test can either be selected from the test mode menu or programmed to operate
automatically at a time of day. The automatic detector test can be programmed not to operate
if an area is set at the programmed test time.
During the detector test all programmed detector test outputs (see Conc/outputs) will be
activated. These outputs should be connected to the circuits which are programmed as
detector circuits. The detector test output(s) will remain on for the programmed test period.
Windsor expects a response from all detector circuits during this time. At the end of the
programmed test time Windsor allows a 10 second settling period. After this time any tested
circuit which is in alarm and would give an alarm response is temporarily bypassed (until
clear). To view or modify the detector test options select option 1 from page 3 of the edit
menus
1=Duration
There are 3 detector test menu options.
2=Time
3=Set Auto Test
Duration
10
10-60 seconds
This is the test duration in seconds. The programmed duration should be sufficient to
guarantee a response from the circuits that are to be tested.
If you want the detector test to be automatic program an auto test time. If you do not want the
automatic detector test option then enter a time of 00:00.
Test Time set to
00:00
Time of day
Press
↵
to change the programmed test time. Windsor will then prompt for the hours and
minutes.
Set Auto Test
On
On/Off
If you want the automatic detector test to operate even when Windsor is set then you must
program set auto test on.