3. Connect the control panel cable to the connector on the system board and lower the
cable latch to secure the cable in place.
4. Using a Phillips #1 screwdriver, install the screws that secure the cable cover to the
system.
After installing the right control panel you could do the following:
1. Install the internal PERC riser.
2. Follow the procedure listed in
After working inside your system
.
System Board
Removing the System Board
CAUTION
: If you are using the Trusted Platform Module (TPM) with an encryption key, you
may be prompted to create a recovery key during program or System Setup. Be sure to
create and safely store this recovery key. If you replace this system board, you must
supply the recovery key when you restart your system or program before you can access
the encrypted data on your hard drives.
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board.
Once the TPM plug-in module is installed, it is cryptographically bound to that specific
system board. Any attempt to remove an installed TPM plug-in module breaks the
cryptographic binding, and it cannot be re-installed or installed on another system board.
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
.
l
Remove the following:
• Air shroud
• All expansion cards and risers
Installing and Removing System Components
System Board
99
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
