2. Holding the blue touch points, align the slot on the internal PERC riser to the guide on the
system board.
3. Insert the internal riser card’s edge connector firmly into the system board connector until
the riser is fully seated.
4. Lift the plunger to lock the riser in place.
5. Connect the cables to the backplane and then route the cables to the cable guiding latch
to close the latch.
After installing the Internal PERC Riser you could do the following:
1. Install the air shroud.
2. Follow the procedure listed in
After working inside your system
.
Removing the PERC card from the internal PERC riser
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
.
l
Remove the air shroud.
l
Remove the internal PERC riser.
Installing and Removing System Components
Internal PERC riser
61
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
