l
If applicable, remove the front bezel.
l
Disconnect the power and data cables from the connectors on the optical drive.
N
OTE
:
Ensure that you note the routing of the power and data cable on the side of
the system and drive. Route these cables properly when you replace them to prevent
them from being pinched or crimped.
Follow the below steps to remove the optional Optical Drive:
1. Press the release tab to release the optical drive.
2. Slide the optical drive out of the system until it is out of the optical drive slot.
3. If you are not adding a new optical drive, install the optical drive blank. The procedure to
install the optical drive blank is the same as the optical drive.
Installing the optical drive
l
Follow the safety guidelines listed in
Follow the below steps to install the optional Optical Drive:
1. Align the optical drive with the optical drive slot on the front of the system.
2. Slide in the optical drive until the release tab snaps into place.
Installing and Removing System Components
Optical drive (optional)
89
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
