b. Tighten the second screw completely.
c. Return to the first screw and tighten it completely.
4.If the PHM slips off the blue retention clips when the screws are partially tightened, follow
these steps to secure the PHM:
a. Loosen both the heat sink screws completely.
b. Lower the PHM on to the blue retention clips, following the procedure described in
step 2.
c. Secure the PHM to the system board, following the replacement instructions listed
in this step above.
N
OTE
:
The processor and heat sink module retention screws should not be tightened
to more than 0.13 kgf-m (1.35N.m or 12 in-lbf).
After installing the Processor Heat Sink Module follow the procedure listed in
Removing the Processor from the Processor and Heat Sink Module
N
OTE
:
Only remove the processor from the processor and heat sink module if you are
replacing the processor or heat sink. This procedure is not required when replacing a
system board.
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
.
Installing and Removing System Components
Processors and heat sinks
56
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
