Follow the below steps to install the System Board:
1. Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other
components.
CAUTION: Take care not to damage the system identification button while placing the
system board into the chassis.
2. Holding the system board holder, align the connector on the system board with the slots
on the back of the chassis and place the system board in place.
3. Using a Phillips #2 screwdriver, replace the screws that secure the system board to the
chassis.
After installing the system board you could do the following:
1. Replace the following:
a. Install the Trusted Platform Module (TPM).
b. Internal PERC riser
c. Internal USB key (if applicable)
d. USB 3.0 module (if applicable)
e. IDSDM/vFlash module card
f. All expansion cards and risers
g. Processors and heat sink modules
h. Processors blanks (if applicable)
i. Memory modules
Installing and Removing System Components
System Board
101
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
