5. Place the heat sink on the processor and push down on the base of the heat sink until the
bracket locks onto the heat sink.
N
OTE
:
●
Ensure that the two guide pin holes on the bracket match the guide holes
on the heat sink.
●
Do not press on the heat sink fins.
●
Ensure that the pin 1 indicator
on the heat sink is aligned with the pin 1 indicator on the bracket before placing the
heat sink onto the processor and bracket.
Internal PERC riser
This describes the procedure to install and remove the Internal PERC Riser.
Removing the internal PERC riser
N
OTE
:
The new generation PERC 11 H750, H350, and HBA350i adapters cannot be
mixed with the PERC H740P, H730P, H330, HBA330 adapters of the previous
generations in one system. For more information, see Cable routing.
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
.
l
Remove the air shroud.
Follow the below steps to remove the Internal PERC Riser:
1. Open the cable guiding latch for easy access.
2. Lower the plunger.
3. Press the cable connector and disconnect the PERC cable from the backplane.
Installing and Removing System Components
Internal PERC riser
59
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
