After installing you do the following:
1. Connect the PSU cables to the connectors on the system board.
2. If applicable, install the expansion card riser.
3. Install the air shroud.
4. Follow the procedure listed in
After working inside your system
Power interposer board
Removing power interposer board
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
.
l
Remove the air shroud
l
Disconnect all the cables connected from the PIB to the system board.
N
OTE
:
Ensure that you note the routing of the cables as you remove them from the
system board.
l
Remove the PSU.
Follow the below steps to remove the Interposer Board:
1. Using a Phillips #2 screwdriver, remove the two screws securing the Power Interposer
Board (PIB) to the system.
2. Lift the board and slide it out at an angle to disengage the guide pins on the board.
Installing and Removing System Components
Power interposer board
94
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
